Stud & Track

Manufacturing

Our grid system for suspended ceilings which has integrated fire expansion joints, has been fully certified for “Reaction to fire” in several

Steel

CIPRIANI profiles are made of carbon steel type DX51D hot-galvanized using the “sendzimir” process with a yield strength exceeding 280 N/mm2 and defined by European Standards UNI EN 10346.

The profiles zinc coating varies depending on profile type:
» C Studs – U Tracks and L Shaped profiles Z 140

All profiles’surface is also protected by chromic acid chemical passivation.
As for the profiles gauge, please refer to profiles individual specifications contained in this catalogue. CIPRIANI has an advanced “In House” laboratory for material testing in order to guarantee high quality and safety to customers.

Storage Suggestions

As humidity and atmospheric agents may oxidize and cause white rust on the surface of the profiles, please take the following precautions:

» Store profiles in covered and ventilated area;
» Keep material away from corrosive agents such as combustion outputs, chemical vapors and dust caused by manufacturing;
» Protect profiles with polyethylene covers which make sure that air is recirculated to avoid condensation;

In case of outdoors storage (not recommended) put the packs at a slight angle to allow any water infiltration to drain freely.
Each profile may be labelled with a bar code upon request.

The products will be:

CW
UW
UW FX
UW PE
SPD
SW
SW PE
SC
SU
SU-PE
LW
MF
UA
UB